Denso 095000-6980 Diesel Injector

On the 3.0L 4JJ1-TC platform, a failing Denso 095000-6980 injector typically presents as: hard or extended cranking; rough or lumpy idle; white, blue or black smoke; hesitation under load, poor fuel economy, diesel knock or rattle; occasional stalling or limp mode.

When two or more of these appear together, suspect the injector before peripheral systems — a comparative leak-off test and live-data cylinder-balance review will isolate the failed unit without tear-down.

The documented failure modes on this platform are: injector wear or internal leakage — balance/compensation values drift out of specification before major drivability symptoms appear; leaking injector diluting the engine oil (rising level, diesel smell in the sump); injector back-leak dragging rail pressure down on high-mileage engines.

Internal wear cannot be repaired in situ — once delivery drifts outside calibration, remanufacture or replacement is the reliable fix.

Read injector balance / compensation values — one cylinder far from the others identifies the failing unit early. Check the engine oil for diesel dilution; a rising level points to a leaking injector on this engine. Run an injector leak-back test on hard-start or P0087 complaints. Denso injectors carry an ID code — register the new code after fitting.

Never condemn a common-rail injector on a fault code alone — codes identify the circuit or cylinder, while leak-off volumes and correction values identify the component.

Each remanufactured 095000-6980 is fully stripped, ultrasonically cleaned and inspected; worn components are replaced with OE-grade parts. The rebuilt unit is then calibrated on a common-rail test bench against the manufacturer's specification sheet — delivery, back-leak and response are all verified before the injector is sealed and despatched with its calibration data on file.

Every unit carries a 12-month parts warranty and free UK delivery.

The 095000-6980 trusted family covers 4 verified vehicle fitments across 3 makes: Isuzu, Holden and Chevrolet. Every fitment listed on this page is registry-verified — no scraped or assumed applications.

095000-6980 supersedes or cross-references 6 further OE numbers, including 8-98011604, 898011604, 8-98011604-1, 8-98011604-5, 095000-6983 and DCRI107800. Always match the reference etched on your failed unit's body — cross-references within a family are verified equivalents, but etched numbers remain the source of truth.