Skip to main content

Ships Worldwide•FREE UK•£50 International

Trade customer? Get Trade Pricing
OEM Tested
12-Month Warranty
Free UK Delivery
Same-Day Dispatch

CAPA Diesel Injectors

Compatible with Audi A8 (D3)

  • OEM Tested & Calibrated
  • 12-Month Warranty
  • Free UK Delivery

Select the correct injector for your CAPA engine below

Fits Audi A8 (D3) and more

Compatible Injectors for CAPA

  • OEM Tested
  • 12-Month Warranty
  • Free UK Delivery
Check CompatibilityCall 020 3355 6581
Order by 2pm — tracked UK courier

Common problems solved by these injectors

About the CAPA engine

The CAPA is a 3.0l v6 tdi common rail diesel engine. This engine uses Bosch diesel injectors.

How Diesel Injectors Are Remanufactured

Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.

Vehicles Using CAPA Engine

VehicleEngineYears
Audi A8 (D3) injector 3.0 TDI2007–2010

Common CAPA Injector Problems

1

Rough idle and engine vibration

Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.

2

Excessive exhaust smoke

Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.

3

Poor fuel economy

A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.

4

Engine misfire under load

Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.

5

Difficult cold starting

Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.

6

Loss of power

Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.

7

Increased diesel knock

Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.

CAPA Technical Specifications

Displacement

—

Power

—

Torque

—

Fuel System

Common Rail Direct Injection

The CAPA is a 3.0l v6 tdi common rail diesel engine. This engine uses Bosch diesel injectors.

Engine Intelligence

VW / Audi 3.0 V6 TDI CR (Touareg, Q7, A4, A6 — early common-rail)

Documented failure modes

  • Piezo injector electrical failure logging group voltage codes
  • Injector back-leak rising with temperature on high-mileage units
  • Fuel contamination damage following HP pump wear

Diagnostic guidance

  • Six-cylinder V layout — compare leak-off volumes across both banks before condemning an injector
  • Group voltage codes usually mean one shorted piezo injector pulling down the shared supply — test each in the group
  • Injector coding via ODIS/VCDS is required after replacement

Fault codes linked to this engine's injectors

Fitment note: The 3.0 V6 TDI spans several generations with different Bosch piezo references — match the number etched on the injector body, not just the engine code.

Browse every diesel engine we cover →

Related CAPA Engine Guides

Related Pages

Bosch 3.0L V6 TDI — browse compatible engines, vehicles, and injectors

More resources for CAPA owners