CAMB Diesel Injectors
Compatible with Audi A8 (D3)
- OEM Tested & Calibrated
- 12-Month Warranty
- Free UK Delivery
Select the correct injector for your CAMB engine below
Fits Audi A8 (D3) and more
Top injectors for CAMB
Compatible Injectors for CAMB
- OEM Tested
- 12-Month Warranty
- Free UK Delivery
Common problems solved by these injectors
About the CAMB engine
The CAMB is a 3.0l v6 tdi common rail diesel engine. This engine uses Bosch diesel injectors.
How Diesel Injectors Are Remanufactured
Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.
Vehicles Using CAMB Engine
| Vehicle | Engine | Years |
|---|---|---|
| Audi A8 (D3) injector | 3.0 TDI | 2007–2010 |
Common CAMB Injector Problems
Rough idle and engine vibration
Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
Excessive exhaust smoke
Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
Poor fuel economy
A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
Engine misfire under load
Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
Difficult cold starting
Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.
Loss of power
Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.
Increased diesel knock
Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.
CAMB Technical Specifications
Displacement
—
Power
—
Torque
—
Fuel System
Common Rail Direct Injection
The CAMB is a 3.0l v6 tdi common rail diesel engine. This engine uses Bosch diesel injectors.
Engine Intelligence
VW / Audi 3.0 V6 TDI CR (Touareg, Q7, A4, A6 — early common-rail)
Documented failure modes
- Piezo injector electrical failure logging group voltage codes
- Injector back-leak rising with temperature on high-mileage units
- Fuel contamination damage following HP pump wear
Diagnostic guidance
- Six-cylinder V layout — compare leak-off volumes across both banks before condemning an injector
- Group voltage codes usually mean one shorted piezo injector pulling down the shared supply — test each in the group
- Injector coding via ODIS/VCDS is required after replacement
Fitment note: The 3.0 V6 TDI spans several generations with different Bosch piezo references — match the number etched on the injector body, not just the engine code.
Related CAMB Engine Guides
Related Pages
Bosch 3.0L V6 TDI — browse compatible engines, vehicles, and injectors
Compatible Vehicles
Recommended Injector
0445116022
Bosch — View product page
