OM642DE30LA Diesel Injectors
Common-rail diesel injectors with full UK warranty
- OEM Tested & Calibrated
- 12-Month Warranty
- Free UK Delivery
Select the correct injector for your OM642DE30LA engine below
Top injectors for OM642DE30LA
Compatible Injectors for OM642DE30LA
- OEM Tested
- 12-Month Warranty
- Free UK Delivery
Common problems solved by these injectors
About the OM642DE30LA engine
The OM642DE30LA is a 3.0l v6 cdi common rail diesel engine. This engine uses Bosch diesel injectors.
How Diesel Injectors Are Remanufactured
Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.
Vehicles Using OM642DE30LA Engine
Vehicle data not yet available for this engine code.
Common OM642DE30LA Injector Problems
Rough idle and engine vibration
Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
Excessive exhaust smoke
Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
Poor fuel economy
A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
Engine misfire under load
Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
Difficult cold starting
Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.
Loss of power
Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.
Increased diesel knock
Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.
OM642DE30LA Technical Specifications
Displacement
—
Power
—
Torque
—
Fuel System
Common Rail Direct Injection
The OM642DE30LA is a 3.0l v6 cdi common rail diesel engine. This engine uses Bosch diesel injectors.
Engine Intelligence
Mercedes 3.0 V6 CDI (OM642 Gen2 — Sprinter, Vito, E-Class, ML, S-Class)
Documented failure modes
- Injector copper seal / seat failure letting combustion gas carbonise around the injector base
- Piezo injector internal faults degrading atomisation and drifting correction values out of range
- Injectors carboning into the bore when seal leaks are left unrepaired, making removal difficult
Diagnostic guidance
- Inspect around every injector for black crust before diagnosis — the failure is often the seal and seat, not the injector body
- Clean or recut the injector seat before fitting a replacement; always use a new copper sealing washer
- Check injector correction values across all six cylinders — an outlier identifies the failing unit
- Address seal leaks early: a long-running leak can seize the injector into the head
Fitment note: OM642 spans multiple variants (.884/.896/.899/.992) across Sprinter, Vito and passenger cars with different Bosch references — match the reference etched on the injector body, not just the engine code.
Related OM642DE30LA Engine Guides
Related Pages
Bosch 3.0L V6 CDI — browse compatible engines, vehicles, and injectors