1AD-FTV Diesel Injectors
Compatible with Toyota Auris (E180), Toyota Avensis III (T27), Toyota RAV4 (XA40), and 1 more
- OEM Tested & Calibrated
- 12-Month Warranty
- Free UK Delivery
Select the correct injector for your 1AD-FTV engine below
Fits Toyota Auris (E180), Toyota Avensis III (T27), Toyota RAV4 (XA40), Toyota Verso (R20) and more
Top injectors for 1AD-FTV
Compatible Injectors for 1AD-FTV
- OEM Tested
- 12-Month Warranty
- Free UK Delivery
Common problems solved by these injectors
About the 1AD-FTV engine
The 1AD-FTV is a 2.0l d-4d common rail diesel engine. This engine uses DENSO diesel injectors.
How Diesel Injectors Are Remanufactured
Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.
Vehicles Using 1AD-FTV Engine
| Vehicle | Engine | Years |
|---|---|---|
| Toyota Auris (E180) injector | 2.0L | 2012–2015 |
| Toyota Avensis III (T27) injector | 2.0L | 2009–2018 |
| Toyota RAV4 (XA40) injector | 2.0L | 2013–2018 |
| Toyota Verso (R20) injector | 2.0L | 2009–2014 |
Common 1AD-FTV Injector Problems
Rough idle and engine vibration
Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
Excessive exhaust smoke
Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
Poor fuel economy
A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
Engine misfire under load
Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
Difficult cold starting
Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.
Loss of power
Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.
Increased diesel knock
Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.
1AD-FTV Technical Specifications
Displacement
—
Power
—
Torque
—
Fuel System
Common Rail Direct Injection
The 1AD-FTV is a 2.0l d-4d common rail diesel engine. This engine uses DENSO diesel injectors.
Engine Intelligence
Toyota 2.0 D-4D (1AD-FTV — Avensis, Auris, Verso)
Documented failure modes
- Injector seal leaks allowing combustion blow-by into the engine bay
- Nozzle wear causing over-fuelling and DPF loading
- Injector leak-back beyond specification
Diagnostic guidance
- Check for injector seal blow-by (chuffing noise, soot around injectors) — a documented issue on AD-series engines
- Denso compensation codes must be registered using the manufacturer diagnostic procedure after fitting
- Run a comparative leak-off test before ordering replacements
Fitment note: 1AD-FTV shares the D-4D platform with 2AD variants but injector references differ — confirm the etched 23670 / DCRI number before ordering.
Related 1AD-FTV Engine Guides
Related Pages
DENSO 2.0L D-4D — browse compatible engines, vehicles, and injectors
