Skip to main content

Ships Worldwide•FREE UK•£50 International

Trade customer? Get Trade Pricing
OEM Tested
12-Month Warranty
Free UK Delivery
Same-Day Dispatch

J3 Diesel Injectors

Compatible with Hyundai H-1, Hyundai Starex, Kia Carnival, and 1 more

  • OEM Tested & Calibrated
  • 12-Month Warranty
  • Free UK Delivery

Select the correct injector for your J3 engine below

Fits Hyundai H-1, Hyundai Starex, Kia Carnival, Kia Sedona and more

Compatible Injectors for J3

  • OEM Tested
  • 12-Month Warranty
  • Free UK Delivery
Check CompatibilityCall 020 3355 6581
Order by 2pm — tracked UK courier

Common problems solved by these injectors

About the J3 engine

The J3 is a kia/hyundai 2.9 crdi (j3/hj3) common rail diesel engine. This engine uses Delphi diesel injectors.

How Diesel Injectors Are Remanufactured

Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.

Vehicles Using J3 Engine

VehicleEngineYears
Hyundai H-1 injector 2.9 CRDi2001–2007
Hyundai Starex injector 2.9 CRDi2001–2007
Kia Carnival injector 2.9 CRDi2001–2006
Kia Sedona injector 2.9 CRDi2001–2006

Common J3 Injector Problems

1

Rough idle and engine vibration

Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.

2

Excessive exhaust smoke

Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.

3

Poor fuel economy

A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.

4

Engine misfire under load

Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.

5

Difficult cold starting

Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.

6

Loss of power

Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.

7

Increased diesel knock

Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.

J3 Technical Specifications

Displacement

—

Power

—

Torque

—

Fuel System

Common Rail Direct Injection

The J3 is a kia/hyundai 2.9 crdi (j3/hj3) common rail diesel engine. This engine uses Delphi diesel injectors.

Engine Intelligence

Kia / Hyundai 2.9 CRDi (J3 — Sedona, Carnival, Carens)

Documented failure modes

  • Delphi injector internal wear causing rising back-leak and smoke
  • Injector electrical faults logging circuit codes
  • Fuel contamination damage following pump wear

Diagnostic guidance

  • Run a leak-off comparison across all four injectors before ordering — multiple failures are common on neglected fuel systems
  • Programme the Delphi injector calibration code after fitting
  • Replace the fuel filter and inspect for contamination whenever an injector is replaced

Fault codes linked to this engine's injectors

Fitment note: J3 engines were fitted with different Delphi references across model years — match the reference etched on the injector body before ordering.

Browse every diesel engine we cover →

Related J3 Engine Guides

Related Pages

Delphi Kia/Hyundai 2.9 CRDi (J3/HJ3) — browse compatible engines, vehicles, and injectors

More resources for J3 owners