BSG Diesel Injectors
Compatible with Audi A6 Avant (4F5, C6), Audi A6 Saloon (4F2, C6)
- OEM Tested & Calibrated
- 12-Month Warranty
- Free UK Delivery
Select the correct injector for your BSG engine below
Fits Audi A6 Avant (4F5, C6), Audi A6 Saloon (4F2, C6) and more
Top injectors for BSG
Compatible Injectors for BSG
- OEM Tested
- 12-Month Warranty
- Free UK Delivery
Common problems solved by these injectors
About the BSG engine
The BSG is a 2.7l v6 tdi cr common rail diesel engine. This engine uses Bosch diesel injectors.
How Diesel Injectors Are Remanufactured
Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.
Vehicles Using BSG Engine
| Vehicle | Engine | Years |
|---|---|---|
| Audi A6 Avant (4F5, C6) injector | 2.7 TDI | 2005–2008 |
| Audi A6 Saloon (4F2, C6) injector | 2.7 TDI | 2004–2008 |
Common BSG Injector Problems
Rough idle and engine vibration
Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
Excessive exhaust smoke
Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
Poor fuel economy
A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
Engine misfire under load
Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
Difficult cold starting
Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.
Loss of power
Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.
Increased diesel knock
Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.
BSG Technical Specifications
Displacement
—
Power
—
Torque
—
Fuel System
Common Rail Direct Injection
The BSG is a 2.7l v6 tdi cr common rail diesel engine. This engine uses Bosch diesel injectors.
Engine Intelligence
Audi / VW 2.7 TDI V6 (BSG / BPP — Bosch piezo)
Documented failure modes
- Piezo injector internal leak-back rising with temperature
- Nozzle tip coking on short-journey duty cycles
- Injector circuit faults from loom or connector degradation
Diagnostic guidance
- Piezo injectors must never be energised with solenoid-type test currents
- Measure back-leak per bank on the V6 — both rails must be compared
- Injector calibration values must be written following the manufacturer procedure after fitting
Fitment note: The 2.7 TDI shares its Bosch piezo platform with 3.0 TDI variants but references differ by output — match the 0445115/0445116 number etched on the injector body.
Related BSG Engine Guides
Related Pages
Bosch 2.7L V6 TDI CR — browse compatible engines, vehicles, and injectors
