Audi A6 Allroad (4FH, C6) BPP Injectors

Audi A6 Allroad (4FH, C6) BPP Overview

The Audi A6 Allroad (4FH, C6) with the BPP 2.7L V6 TDI CR engine was produced between 2006 and 2008. This vehicle uses Bosch common rail diesel injectors (primary part number 0445115039) operating at fuel pressures up to 2000 bar. The BPP engine in the Audi A6 Allroad (4FH, C6) produces and of torque. When replacing injectors on the Audi A6 Allroad (4FH, C6) BPP, always use new copper sealing washers and torque to manufacturer specifications. Each injector should be coded to the ECU after fitting.

Compatible Injectors

Common Injector Problems in Audi A6 Allroad (4FH, C6)

• •
  Rough idle and engine vibration — Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
• •
  Excessive exhaust smoke — Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
• •
  Poor fuel economy — A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
• •
  Engine misfire under load — Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
• •
  Difficult cold starting — Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.

Other BPP Vehicles

Related Pages

Bosch 2.7L V6 TDI CR — browse compatible engines, vehicles, and injectors