Skoda Karoq CUWA Injectors

Skoda Karoq CUWA Overview

The Skoda Karoq with the CUWA VW/Audi 2.0 TDI (EA288 Gen2) engine was produced between 2018 and 0. This vehicle uses Bosch common rail diesel injectors (primary part number 0445110470) operating at fuel pressures up to 2000 bar. The CUWA engine in the Skoda Karoq produces and of torque. When replacing injectors on the Skoda Karoq CUWA, always use new copper sealing washers and torque to manufacturer specifications. Each injector should be coded to the ECU after fitting.

Compatible Injectors

Common Injector Problems in Skoda Karoq

• •
  Rough idle and engine vibration — Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.
• •
  Excessive exhaust smoke — Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.
• •
  Poor fuel economy — A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.
• •
  Engine misfire under load — Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.
• •
  Difficult cold starting — Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.

Other Engine Codes for Skoda Karoq

Other CUWA Vehicles

Related Pages

Bosch VW/Audi 2.0 TDI (EA288 Gen2) — browse compatible engines, vehicles, and injectors