Skip to main content

Ships Worldwide•FREE UK•£50 International

Trade customer? Get Trade Pricing
OEM Tested
12-Month Warranty
Free UK Delivery
Same-Day Dispatch

DW10FCC Diesel Injectors

Compatible with Citroen C4, Citroen C5, Citroen DS4, and 14 more

  • OEM Tested & Calibrated
  • 12-Month Warranty
  • Free UK Delivery

Select the correct injector for your DW10FCC engine below

Fits Citroen C4, Citroen C5, Citroen DS4, Citroen DS5 and more

Compatible Injectors for DW10FCC

  • OEM Tested
  • 12-Month Warranty
  • Free UK Delivery
Check CompatibilityCall 020 3355 6581
Order by 2pm — tracked UK courier

Common problems solved by these injectors

About the DW10FCC engine

The DW10FCC is a 2.0l hdi common rail diesel engine. This engine uses Delphi diesel injectors.

How Diesel Injectors Are Remanufactured

Watch our 3D walkthrough of the diesel injector remanufacturing process and see how injectors are professionally restored for reliable service.

Vehicles Using DW10FCC Engine

VehicleEngineYears
Citroen C4 injector 2.0 HDi2010–2018
Citroen C5 injector 2.0 HDi2009–2017
Citroen DS4 injector 2.0 HDi2013–2018
Citroen DS5 injector 2.0 HDi2013–2018
Citroen Jumpy injector 2.0 HDi2016–2023
Ford C-Max injector 2.0 TDCi2015–2018
Ford Edge injector 2.0 TDCi2016–2018
Ford Focus injector 2.0 TDCi2015–2018
View all 17 vehicles

Common DW10FCC Injector Problems

1

Rough idle and engine vibration

Worn injector nozzles cause uneven fuel spray, leading to rough idle at low RPM. Most noticeable when the engine is cold.

2

Excessive exhaust smoke

Black or blue-grey smoke on acceleration indicates poor fuel atomisation. This is often caused by carbon buildup on the injector nozzle tip.

3

Poor fuel economy

A worn or leaking injector delivers incorrect fuel quantities, reducing efficiency by 10–20% in severe cases.

4

Engine misfire under load

Intermittent misfires during acceleration suggest one or more injectors are failing to deliver the correct fuel pressure.

5

Difficult cold starting

Degraded injector nozzles struggle to atomise fuel at lower cranking pressures, causing extended crank times in cold weather.

6

Loss of power

Gradual power loss across the rev range, particularly above 2500 RPM, can indicate injector flow rate degradation.

7

Increased diesel knock

Louder than normal combustion noise, especially at idle, can indicate incorrect injection timing due to worn injector internals.

DW10FCC Technical Specifications

Displacement

—

Power

—

Torque

—

Fuel System

Common Rail Direct Injection

The DW10FCC is a 2.0l hdi common rail diesel engine. This engine uses Delphi diesel injectors.

Engine Intelligence

PSA / Ford 2.0 HDi / BlueHDi / EcoBlue (DW10F — Delphi era)

Documented failure modes

  • Injector back-leak beyond specification, dropping rail pressure at start
  • Nozzle carbon build-up causing over-fuelling and DPF loading
  • Injector seat sealing failure allowing combustion gas blow-by

Diagnostic guidance

  • Run a comparative leak-off test across all four injectors before condemning one
  • Inspect injector seats for carbon and clean before fitting — reusing a fouled seat causes repeat failures
  • Delphi injectors on this platform carry calibration data that must be registered following the manufacturer procedure after fitting
  • If rail-pressure codes accompany injector codes, verify the high-pressure pump and regulator before replacing injectors

Fault codes linked to this engine's injectors

Fitment note: The 2.0 DW10F/EcoBlue era spans PSA and Ford applications with different Delphi references by output and emissions stage — always match the number etched on the injector body.

Browse every diesel engine we cover →

Related DW10FCC Engine Guides

Related Pages

Delphi 2.0L HDi — browse compatible engines, vehicles, and injectors

More resources for DW10FCC owners